Uses

• Grouting ceramic tiles.
• Grouting terrazzo and mosaic tiles.
• Grouting porcelain tiles.
• Grouting marble and natural stone.
• Dry and humid conditions.

Advantages

• Water resistant.
• Suitable for dry and humid conditions.
• High colour fastness.
• High resistance to dirt pickup.
• Available in a wide range of colours.
• Suitable for different types of tiles and natural stone.
• Good workability and easy cleaning.
• Rapid curing, high compressive strength and low shrinkage.

Joint Preparation

• Ensure that the tiles are securely fixed and that the tile adhesive has dried thoroughly before applying any load or pressure. Remove excess adhesive from the joints to provide an even and consistent grout depth.
• Natural stone and unglazed tiles may absorb fine grout particles and may be susceptible to surface discolouration. Test the mixed grout on a spare tile and follow the tile manufacturer’s sealing recommendations where applicable.

Standards Compliance

• Complies with EN 13888, class CG2.
• Complies with ANSI A118.7.

Mixing

1. Add WHITE SAND TILE GROUT to clean water in a clean container while mixing mechanically.
2. Mix thoroughly to obtain a smooth, consistent and easily workable mortar.
3. Use the recommended amount of water and do not add more than necessary.
4. Do not freshen partially used grout with additional water; discard it once it loses workability.
5. For large areas, use material from the same batch and maintain an identical water addition for every mix.

Application

1. Apply the mixed grout using a rubber blade, grouting trowel, rubber spatula or smooth sponge.
2. Press the grout firmly into the joints to fill all gaps completely.
3. Remove excess grout remaining on the tile surfaces.
4. After initial drying, clean the tiles with a wet sponge.
5. After the grout dries fully, complete the cleaning with a dry cloth or disposable cotton towels.
6. Do not rub too deeply into the tile joints during washing or drying.

Coverage

The required grout quantity depends on tile height and width, joint depth or tile thickness, joint width, grout coverage ratio and total tiled area.

The data sheet gives a WHITE SAND TILE GROUT coverage ratio of 1.5 and recommends adding approximately 10% to the estimated quantity for spillage and wastage.

Cleaning

Clean all tools with water immediately after completing the application. Hardened material must be removed mechanically.

Storage and Shelf Life

Minimum shelf life is 12 months in unopened and undamaged bags under dry warehouse conditions at an ambient temperature of 5-35°C.

Packaging

10 kg paper bags.

Health and Safety

• Suitable protective gloves and safety goggles are recommended during handling, mixing and application.
• Avoid unnecessary direct contact with the skin and eyes.
• In case of skin contact, wash immediately with soap and clean water.
• In case of eye contact, rinse immediately with plenty of clean, cold water.
• Seek medical advice if irritation continues.
• The product is non-flammable and is not classified as hazardous under current legislation.
• Do not dispose of the material in water or soil. Follow applicable local disposal regulations.

Quality and Technical Support

WHITE SAND products are developed and manufactured through quality-oriented product development processes and an independently standardized quality management system.

WHITE SAND provides site support, consultations and technical advice regarding substrate preparation and treatment, product selection and correct application techniques.