White Sand Finish Coat is used to:

• Fill small surface voids
• Smooth wall and ceiling surfaces
• Level minor undulations
• Prepare surfaces before painting
• Improve surface finish quality
• Create a smooth decorative substrate

It is suitable for both interior and exterior applications.

The product can be applied on:

• Concrete surfaces
• Sand cement render
• Cementitious substrates
• Mineral-based surfaces

The substrate should be clean, sound, and free from contaminants before application.

Yes. White Sand Finish Coat is formulated for:

• Interior wall finishing
• Exterior wall finishing
• Ceiling applications
• Humid and dry environments

It is also suitable for tropical and hot climate conditions.

Key benefits include:

• Excellent filling performance
• High smoothness
• Water resistance
• High bond strength
• Slump-free consistency
• No sagging on vertical surfaces
• Compatibility with decorative paints
• Easy application properties

Yes. The product is designed with water-resistant properties, making it suitable for humid conditions and exterior applications.

For each 25 kg bag, approximately:

• 9–10 liters of clean water

should be added during mixing.

Recommended mixing procedure:

1. Add clean water to a mixing container
2. Slowly add powder while mixing
3. Use a low-speed electric drill with mixing paddle
4. Mix for at least 2 minutes until smooth and lump-free
5. Allow the mixture to rest for about 5 minutes
6. Remix before application

The product has an approximate pot life of:

• 1 hour

Mixed material should be used within the working time and should not be remixed after setting begins.

White Sand Finish Coat can be applied:

• Up to 3.0 mm thickness
• Using multiple thin layers

Each layer should dry before applying the next coat.

Yes. The product is suitable for:

• Vertical wall surfaces
• Ceiling applications

Its slump-free and non-sagging consistency supports overhead applications.

Application steps include:

• Dampening the substrate
• Applying the material using a putty knife
• Building thin layers gradually
• Allowing drying between coats
• Sanding the final coat for smoothness

The manufacturer recommends not using a mason trowel.

Yes. Proper substrate preparation is essential.

The surface should be:

• Clean
• Structurally sound
• Free from dust and loose particles
• Free from oils and contaminants
• Slightly damp before application

Yes. Decorative paints and coatings can be applied after the finish coat has completely dried.

Approximate coverage:

• 1.5–1.8 kg/m² at 0.5 mm thickness

Actual consumption may vary depending on substrate condition and application thickness.

Curing is generally not required under normal conditions.

However, in:

• High temperatures
• Strong wind conditions

light water curing for at least 48 hours is recommended.

White Sand Finish Coat is available in:

• White
• Grey

The product achieves:

• Bond strength ≥ 0.5 MPa after 28 days

at 0.5 mm thickness.

White Sand Finish Coat is supplied in:

• 25 kg paper bags

The product has:

• 12 months shelf life

when stored:

• In dry shaded conditions
• Below 35°C
• In unopened original packaging

Tools should be cleaned immediately with:

• Clean water

Hardened material must be removed mechanically.

Yes, but appropriate protective measures are recommended:

• Wear gloves and goggles
• Avoid direct skin and eye contact
• Wash exposed skin immediately with water
• Rinse eyes thoroughly if accidental contact occurs

No. The product is described as:

• Non-flammable
• Not classified as hazardous under current legislation

The product is suitable for:

• Tropical climates
• Hot weather conditions
• Humid environments
• Dry conditions

White Sand Finish Coat offers:

• Smooth finishing performance
• Strong adhesion
• Water resistance
• Easy workability
• Compatibility with decorative coatings
• Reliable interior and exterior application performance

It is designed for professional wall preparation and finishing applications.